Honda VTX1800F Left/ Right Floor Board Assembly Installation Manual
download 1. Unplug the horn wires. 2. Unbolt the left side foot peg bracket assembly and save the hardware, the stock bolts will be used to install your new Cobra floorboards. 3. Remove horn and the...
View ArticleKAWASAKI Turn Signal Conversion Kit Installation Instructions
download 1. Place motorcycle on solid, level ground and on center stand if equipped. 2. Remove your turn signal lens. Place it upside down and clean the lens interior with the supplied alcohol wipe....
View ArticleHONDA GL1800 DRIVER BOARD SETS WITH HEEL TOE SHIFTER INSTALLATION MANUAL
download Note: Read instructions thoroughly before installing. 1. Place bike on center stand. 2. Remove the two bolts that hold the stock left side foot peg bracket and remove bracket and foot peg....
View ArticleHARLEY DAVIDSON SKULL FOOT BOARD INSERT KITS INSTALLATION MANUAL
download Kit 50704-04 is an Operator Footboard Insert Kit. •This kit fits all 2004 and later FLHRS/I (Road King® Custom) model motorcycles. •This kitalso fits 1986 and later FLHR/I/CI, FLHT/C/CI/CUI...
View ArticleCUSTOM LED 2004-2006 YAMAHA ROAD STAR INTEGRATED TAIL KIT INSTALLATION...
download 1 ) REMOVE THE SCREWS ON THE BACK SIDE OF THE TAIL LIGHT THAT HOLD THE CHROME TRIM TO THE TAIL LIGHT. 2 ) POSITION YOUR CUTTING WHEEL AS SHOWN IN THE PICTURE TO THE LEFT WHERE THE CLEAR PART...
View Article2005-2010 TACOMA RUNNING BOARD REPAIR
download Care must be taken when installing this accessory to ensure damage does not occur to the vehicle. The installation of this accessory should follow approved guidelines to ensure a quality...
View ArticleV-Star 1100 Floorboard/ Foot peg Extension Kit Installation Manual
download 1. Take notice of the position of the shift peg positions relative to the floorboard or foot-peg. You will be adjusting it back to these locations upon installation of the extended linkage. 2....
View Article2005 TRIUMPH SPEED TRIPLE AND SPRINT ST INTEGRATED TAIL KIT INSTALLATION...
download 1 ) PLACE THE TAIL LIGHT ASSEMBLY ON A SOFT SURFACE TO AVOID SCRATCHING OR DAMAGING THE LENS DURING THE CUTTING OPERATION. 2 ) POSITION YOUR CUTTING WHEEL AS SHOWN IN THE PICTURE TO THE LEFT...
View Article1981-1983 Yamaha Virago 750 & 920 Installation Instructions
download Start by loosening the rear cylinder down tube bolt located on the top of the old mufflers center collector in front of the rear tire. 2. Remove both of the front cylinder exhaust pipe head...
View Articlemotorcycle Turn Signal Conversion Kit Installation Instructions
download 1. Place motorcycle on solid, level ground and on center stand if equipped. 2. Remove your turn signal lens. Place it upside down and clean the lens interior with the supplied alcohol wipe....
View Article